@Clive_A Ok, i have also resetted the SG3218XP-M2. Firmware 1.0.3 is now installed. Thank you for your help!

@Clive_A Thank you very much! I have done a full-reset via USB-Serial-Connection (Omada-Controller couldn't resetting the switch after forget-command) and the Firmware 1.0.3 is now installed. Is my...

@Clive_A Thank you for your reply and for the information that die issue will be addressed. :) The previous firmware was version 1.0.3, but on your website is only version 1.0.2 available.

@Clive_A Yes, the OC200-Hardware-Controller and all the other Omada-Hardware are in the same subnet. The SG3210X-M2 has the correct configuration and working absolute fine. But the Omada-Controller...

@Clive_A The SG3210X-M.2 is configurated with a static IPv4-Address. On every reboot the Switch will be displayed with disconnected anyway. With Firmware-Version 1.0.3 this issue was not happen.

Hello, today was the Firmware-Update-Day in my Omada-Network. For my SG3210X-M2 V1 Switch was the newest Firmware-Version 1.0.5 (previous Firmware was 1.0.3). The Firmware-Update Start was proceeded...