@nickone1 If the RC controller is on the network, you should be able to ping it. You should also see it on the client list of the AP in Omada Controller. Its IP address should be show, too, since APs...

@nickone1 Some simple Wi-Fi devices cannot properly connect when the same SSID is set up on two different APs. Create a new 2.4 GHz SSID on only one AP and give it a try.

@JFrisbee You connect FortiGate to the switch using two separate links and you have single subnets there. This makes me think that FortiGate sends untagged frames to the switch. If that's the case,...

@JFrisbee The configuration of your TP-Link switch may be right, but it all depends on the configurations on the other side of the links. I can’t figure it out from your description. I’m not familiar...

@sonaric A VLAN interface is basically a routed interface (gateway) for a particular VLAN. On a L3 switch, it can be usually created only after routing is enabled on it. A VLAN interface is not...

@DanFMT You need a new router in that case. ER605 seems to be a popular choice and you can use it with Omada and without. Buy it from a seller that has at least 1 month no-question-asked refund...