danymarc wrote If you are able to connect via LAN1, set it up right Reset 220 through web interface, it's important you do this, cause you had made many changes set a ip to 220 on same subnet as main...

danymarc wrote Pharos line uses POEcan you explain whats quoted on bold, cause I do not understand how you are able to connect to 220 without the POE (power unit) Sure, by direct to the device I mean...

danymarc wrote 1-did you buy patch cable, or you guys did the crimp, then it could be a bad crimp. Bought a cable 2- it appeared to be working we will never know reality We can be 100% certain that I...

danymarc wrote feelings and not been certain, are a bad combination to get you going. bring down your CPE, Reset to defaults and start over, should never been deploy outside if you didnt do test with...

Yes, this is exactly what I did before I mounted it on the roof. The setup is as you described Router(LAN)--CPE2010 ))(( phone/laptop I cannot login to change the IP of the CPE210. I have a feeling...

Thanks for your messages. I've not changed the IP address since it was set up - followed the instructions at used 192.168.1.10 Yes, I tried setting the static ip address on my PC - same as when I set...