@Hank21 Yes, on the latest firmware it works after disabling WPA3 and PMF. I don't know if PMF was enabled on the 5.1.0 firmware, but WPA3 support definitly was enabled. Of course I think WPA3 should...

@Hank21 I'm using the software controller version 5.13.30.8. My devices are 2 x EAP225 V3 and 1 x EAP225-Outdoor V3. I've disabled WPA 3 and PMF, for which I needed to deselect 6GHz otherwise WPA3...

@Hank21 After upgrading a Windows 10 PC crashed (blue screened) when connecting to the WiFi. Stop code: DPC WATCHDOG VIOLATION. it uses a TP-Link Archer T2u Plus wifi adapter. It does not make a...

And add portfast (edge port), as this is currently not possible and required in a number of scenarios. I't generally enabled on access ports to allow for instance PXE boot.

Common scenario to implement STP/RSTP/MST on network switches is to enable is on all ports and configure access ports with portfast. This is also the recommendation within the configuration guide on...

@Fae thank you for your quick response. I've just updated my original post, before I've seen your answer. In short, the native web UI of the switch does support the configuration I require. So it...