OC300 firmware update of connected devices
I have a problem with updating firmware of the connected devices (access points, switches) via OC300 controller. I receive a notification, that a firmware upgrade is available, that I should go to global view, firmware to check it. And the devices to be updated are listed there OK. But there is no way to update the firmware - you need to have the downloaded firmware file first. When I try to locate this file in the support section of TP-Link downloads page, it just lists the firmware for the requested device which are even older, than I have at present. Namely for the following devices - EAP225(EU) v3.0, EAP225-Outdoor(EU) v1.0, TL-SG2008 v3.0, TL-SG2008P v1.0. Could you please send me links to the new firmware of the listed above devices?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I have already tried that. The only wizard that starts after that is "Set Upgrade Rule" wizard, please see the picture below. "Next" is grayed out. And no target version.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 82
Replies: 7
Voters 0
No one has voted for it yet.