Hello.

 

It is the first time i post on this forum, I hope to be in the correct place.

 

i need help with my wifi.

 

I will quickly describe my hardware

I have optical fiber internet connection with the cable that enters my house and goes into a FritzBox router.

To cover all the house I used a 

switch TL-SG1210P with PoE ports, the switch is connected to 5 access points EAP 115

 

Router and switch were powered by an UPS. I lef home for 7 days and as I was back the UPS was dead, so I powered the devices directly bypassing the UPS and everything started.

 

After everything was booted this was the situation:

1. the wifi lan still exists but it is without internet

2. the FritzBoz built in (low range) wifi works with internet

 

So something is wrong with the TP Link Access point setup.

 

I configured the Access Points years ago before formatting my pc, somehow the devices still work (in fact he wifi with the password i set is still valid), but i am not able to access the configuration.

 

I tried to install omada controller again, but i can't find a way to use my old settings (likely they are lost since after my pc has been formatted).

 

Anyway if i creaet a new profile I can see my devices:

but they are in fact "MANAGED BY OTHERS", because they were configured by myself on my old system.

 

Is there a way I can override the old configuration and take control of the devices? Or should I reset them all one by one?

 

Could you please suggest how would you proceed in this scenario?

 

Thanks.