Cannot bind TP Link ID

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Cannot bind TP Link ID

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Cannot bind TP Link ID
Cannot bind TP Link ID
2024-04-08 03:06:40 - last edited 2024-05-06 11:34:24
Model: VIGI NVR1008H-8P  
Hardware Version: V1
Firmware Version: 1.0.1 Build 230530 Rel. 79659n

I use Starlink to access the Internet.

My internet connection according to the Network set up screen is "Connected to the internet". 

UPnP is showing as inactive.  Platform Access to VIGI VMS is on but showing "waiting for connection"

Using Rapid Diagnosis - Gateway connection OK Extranet Connection OK Cloud Service Connection FAILED

I also get a Firmware failure if I try an update.

I have one camera up and working fine. Using Vigi App I can see the camera as well.

  2      
  2      
#1
Options
1 Accepted Solution
Re:Cannot bind TP Link ID-Solution
2024-04-28 10:18:00 - last edited 2024-05-06 11:34:24
I reinstalled and now working. Sorry for slow response but power has been out and my testing disrupted.
Recommended Solution
  0  
  0  
#3
Options
2 Reply
Re:Cannot bind TP Link ID
2024-04-08 05:29:21
Hi! If the Access to VIGI VMS is enabled, the device will be not able to access to the Cloud, that's why you cannot bind TP-Link ID or check for update from cloud. Please turn off the platform access and try again.
VIGI Technical Support Learn more about VIGI VMS
  1  
  1  
#2
Options
Re:Cannot bind TP Link ID-Solution
2024-04-28 10:18:00 - last edited 2024-05-06 11:34:24
I reinstalled and now working. Sorry for slow response but power has been out and my testing disrupted.
Recommended Solution
  0  
  0  
#3
Options