2 WAN incoming traffic
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Trying to use 2 ISP (WAN/LAN4 and WAN/LAN5) with static IP to serve on port 443.
WAN/LAN4 working fine but WAN/LAN5 not working. It takes 17 seconds to get a response when both WAN are active.
Note: WAN/LAN4 take 2 seconds and its expected.
Only configuration done is setup internet and Virtual Servers
Any help?
Thank you.
Hello,
Sorry for attaching lots of images.
Tried with WAN/LAN4, WAN/LAN5 or WAN/LAN4, WAN/LAN6.
Also tried 3 WAN/LAN with Static IP and PPPoE connection, results are same.
Work fine with single WAN/LAN.
Timeout are set to 10 secends. WAN/LAN4 not working and WAN/LAN5 not stable, getting timeout.
Both ips are responding to ping when ping to WAN are enabled.
Tried hard reset, reboot.
Running on WAN/LAN4 single wan mode working fine. Bellow image
Load balancing and Link backup are not configured. Online Detection set to ip 1.1.1.1
Hi @sanGg
Thanks for posting in our business forum.
Have you read this or any configuration guide? I have seen a mistake in your config. I don't know why you did not do it. But please read some guides about the load balance and link backup.
And I recommend you upgrade your firmware as well which you don't seem to read that part?