EAP245 - Problem with VLAN 1
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I just replaced my old AP (very old, and other brand) with EAP245.
VLAN configuration is very simple :
- No dedicated Management VLAN
- VLAN 1 (LAN) for internal use
- VLAN 10 for guests
- Port configuration on switches : Trunk ; 1 Untagged ; 10 Tagged
- There is a DHCP server in each VLAN
SSID :
- Private on VLAN 1
- Public on VLAN 10
With old AP, this simple configuration was working fine.
I installed Omada SW controller (version 5.13.22) and configured the AP, using identical cables and switch configuration as before (nothing changed).
Discovery and management of AP has been done without any problem.
The 2 SSID are correctly broadcasted, and users can connect to both.
Public SSID (linked to VLAN 10) is working fine.
However... there is a major problem with Private SSID (VLAN 1).
The users can connect to the AP (authentication OK) but... they never received an IP.
Even using a fixed IP (in VLAN 1) on PC, it is impossible to reach any IP (even in VLAN 1).
The AP can be pinged in VLAN 1. But it is the only possible communication.
Could you please help to solve this issue ?
Thanks in advance.
