ER605 - IPSec VPN / Remote Subnets & Adopting ER605 to remote OC200
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I have an IPSEC connection setup between a ER7206 & ER605 in the following design.
ER7206 (Hub) <-> ER605 (Spoke)
Connections work fine to each other to the primary LAN over the IPSEC connection. The issue I'm having is I want to define more than 1 remote network on the ER605 to route to the ER7206. The goal is I want defined network traffic to pass through the tunnel through the ER7206 before going out to the internet. So somewhat of a split horizon routing method. Is this possible? I only see the ability to add a single subnet as the remote side on the ER605.
I also have a OC200 controller on the ER7206 network, and I was trying to figure out how to connect to the ER605 via the WAN side to control it as well so I can controll it via the OC200, but I can't seem to figure out how to have it discover that device.
Thanks,
Lyle
@Clive_A Well, an IPSec configuration can do this since the 7206 has the ability to specify multiple subnets, but the ER605 can't because the option isn't there. I would have thought that the implementation would be the same for IPSec regardless of the platform. I guess I'll have to look into another solution unless this 'feature' can be added to the ER605 to allow multiple subnets to be defined like the ER7206.
So I have the ablity to configure it one direction, but not the other.