Home

Forums

Stories

Knowledge Base

Business Community > All Threads > EAP Disconnect after succesfully adopt into omada controller

< All Threads

EAP Disconnect after succesfully adopt into omada controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP Disconnect after succesfully adopt into omada controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

asyraftaqi

2023-09-14 04:34:05 - last edited 2023-09-15 02:01:05

Posts: 2

Helpful: 0

Solutions: 1

Stories: 0

Registered: 2023-09-13

EAP Disconnect after succesfully adopt into omada controller

2023-09-14 04:34:05 - last edited 2023-09-15 02:01:05

Model: EAP620 HD

Hardware Version: V3

Firmware Version: Version:1.0.5 Build 20220921 Rel. 73357

after setup eap620 hd on vlan11. omada controller can detect and i can even go into management portal on my pc vlan27. even discovery utility can detect.

after adopt into omada controller 5.9, it show connected. after several minutes. EAP disconnected. SSID not showing on wireless. i cant even ping it.

please advise.

1 Accepted Solution

asyraftaqi

LV1

2023-09-14 10:23:01 - last edited 2023-09-15 02:01:05

Posts: 2

Helpful: 0

Solutions: 1

Stories: 0

Registered: 2023-09-13

Re:EAP Disconnect after succesfully adopt into omada controller-Solution

2023-09-14 10:23:01 - last edited 2023-09-15 02:01:05

Seems that i able to connected to vlan environment for my eap on qnap docker container.

i am using fortigate 80E as my firewall and router for vlan on lacp mode.

dell powerconnect switch 5448.

this is my first time using omada controller.

1. reset eap

2. configure fallback ip using vlan ip you are using, ex: mine using vlan 11

3. switch need to be on mode switchport access vlan

4. omada controller will detect your eap.

Cheers. hope this will help

Recommended Solution

1 Reply

asyraftaqi

LV1

2023-09-14 10:23:01 - last edited 2023-09-15 02:01:05

Posts: 2

Helpful: 0

Solutions: 1

Stories: 0

Registered: 2023-09-13

Re:EAP Disconnect after succesfully adopt into omada controller-Solution

2023-09-14 10:23:01 - last edited 2023-09-15 02:01:05

Seems that i able to connected to vlan environment for my eap on qnap docker container.

i am using fortigate 80E as my firewall and router for vlan on lacp mode.

dell powerconnect switch 5448.

this is my first time using omada controller.

1. reset eap

2. configure fallback ip using vlan ip you are using, ex: mine using vlan 11

3. switch need to be on mode switchport access vlan

4. omada controller will detect your eap.

Cheers. hope this will help

Information

Helpful: 0

Replies: 1

EAP Disconnect after succesfully adopt into omada controller

EAP Disconnect after succesfully adopt into omada controller

Information

Voters 0

Tags