Wireguard config
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi all
I have a 605 in my server location (Site A) that I'm attempting to establish a Wireguard connection to from a router running OpenWRT (site B). I keep hitting snags as it appears the connection is established (handshake and packet transfers) but devices my site B that are routed through the VPN fail to obtain an internet connection. I've noticed I'm not able to add more than one Allowed IP on the 605 side.
Is it possible to run a WG tunnel between these routers? Ideally it's not site to site but rather client to site.
Thank you!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @thisisliam
Thanks for posting in our business forum.
How to configure WireGuard VPN on Omada Router in Standalone mode?
Config parameters would be similar to what you have in Controller mode.
After setting up the Wireguard on ER605, then you gotta go and config on the other router. Set the Interface to another router. After you specify the interface, make sure you set it to the peer on the ER605.
This is an interface not existed on your ER605(avoid a conflict).
- Copy Link
- Report Inappropriate Content
is your configured ips for vpn clients belongs to a VLAN other then default (vlan 1)?
If so get the out of it and it should be all okay.
- Copy Link
- Report Inappropriate Content
@Bonesoul - thanks for replying! I'm afraid I don't follow. Are you saying I should create a new VLAN?
- Copy Link
- Report Inappropriate Content
check this: https://community.tp-link.com/en/business/forum/topic/607558?replyId=1217910
If you assign your vpn clients an internal IP that belongs o a custom VLAN, it'll cause a similar situation to yours.
- Copy Link
- Report Inappropriate Content
Hi @thisisliam
Thanks for posting in our business forum.
How to configure WireGuard VPN on Omada Router in Standalone mode?
Config parameters would be similar to what you have in Controller mode.
After setting up the Wireguard on ER605, then you gotta go and config on the other router. Set the Interface to another router. After you specify the interface, make sure you set it to the peer on the ER605.
This is an interface not existed on your ER605(avoid a conflict).
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1094
Replies: 4
Voters 0
No one has voted for it yet.