Access to OpenVPN clients connected to Omada
Hello,
I have an R605 acting as OpenVPN server with network 172.16.5.1/24, set as split tunnel
Client gets VPN IP of 172.16.5.10, Client's LAN network is configured as 192.168.69.1/24
Client is able to access the 172.16.x.x network just fine, however it is not pingable at ip 172.16.5.10 nor 192.168.69.1
I believe i'm missing some static route but I can't figure this out, any help is appreciated
thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @NinjaMonkey
Thanks for posting in our business forum.
Then what do you set in here? Are your subnets included there?
- Copy Link
- Report Inappropriate Content
Hi @Clive_A
Thanks, "All" is selected in that field,
i have also attached a small diagram to better describe the issue
hope this is achievable
- Copy Link
- Report Inappropriate Content
Hi @NinjaMonkey
Thanks for posting in our business forum.
Is there even a tunnel established between the server and the client site?
I think the tunnel is not even up. If the tunnel is up, the gateway IP on each side would be pingable.
- Copy Link
- Report Inappropriate Content
Hi @Clive_A ,
yes i'm certain that the tunnel is up, and communication is possible in one direction thanks to this, but it does not go the reverse way, from the server network to the client network.
is there any special configuration that needs to be done to achieve site-to-site via openvpn? Iv'e found a ton of guides on their own forums but they all seem to apply to windows or linux based servers, where i can access the server config files, with omada this is not the case sadly.
- Copy Link
- Report Inappropriate Content
Hi @NinjaMonkey
Thanks for posting in our business forum.
No. Figure out what client-to-site is. No special configuration. There is not. Consider IPsec for site-to-site.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 434
Replies: 5
Voters 0
No one has voted for it yet.