OC200 - not connecting to cloud - solution
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
OC200 - not connecting to cloud - solution
Original Thread :
OC200 - not connecting to cloud
2020-02-09 00:45:43 - last edited 2020-02-11 09:32:11
Model: OC200
Hardware Version: V1
Firmware Version: 1.21
I have just purchased a OC200 for my network. I have 2 EAP225s that work great. I have the software contoller installed on my PC. I have the OC200 powered by the usb and the network plugged into the poe port. I do have internet connection. When i try to bind the OC200 it says Failed to add your Cloud Controller - device not found. I have reset the OC200 and i can get to the 192.168.0.253 recovery page. I reboot and then nothing. It looks like it does not connect to internet. I have looked at my DHCP list and i dont see it. Any help would be appreciated. Otherwise i will just return and use the software controller on my PC.
-------------------------------------
Just a quick update that it is not BRICKED when you are in recovery mode. I experienced it earlier and what i did is to factory reset it and upon boot up, i pressed on the reset slot with a needle and waited till it blinks and stop ( about 50 secs ). Then when i access the fallback IP ( 192.168.0.253 ) it is restarting ( up to 4-5 mins till 100 % ) and voila! Its good as new again.
