Home

Forums

Stories

Knowledge Base

Business Community > All Threads > EAP245v3 Mesh in Standalone Mode

< All Threads

EAP245v3 Mesh in Standalone Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP245v3 Mesh in Standalone Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Bensch

2023-05-28 16:53:16 - last edited 2023-05-30 16:43:22

Posts: 8

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2023-05-28

EAP245v3 Mesh in Standalone Mode

2023-05-28 16:53:16 - last edited 2023-05-30 16:43:22

Tags: #Mesh

Model: EAP245

Hardware Version: V3

Firmware Version: 5.1.0

Hi,

I have two EAP245 v3 with the newest Firmware. In the release notes you wrote

"Add support for Mesh feature in Standalone mode (Requires Omada APP v4.6.x or above)."

How to set this up?

Currently I have one EAP245 as AP on my wired Network and the other EAP245 is atm not in use.

I want to use it as Mesh Repeater without an OC200. Is this possible?

Thanks

1 Accepted Solution

Hank21

2023-05-30 06:39:26 - last edited 2023-05-30 16:43:22

Posts: 3673

Helpful: 718

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:EAP245v3 Mesh in Standalone Mode-Solution

2023-05-30 06:39:26 - last edited 2023-05-30 16:43:22

Hello @Bensch,

You may refer to this FAQ on the official website to set the Mesh network in Standalone mode.

How to configure your EAP access points into a Mesh Network using the Omada App

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

Recommended Solution

2 Reply

Hank21

2023-05-30 06:39:26 - last edited 2023-05-30 16:43:22

Posts: 3673

Helpful: 718

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:EAP245v3 Mesh in Standalone Mode-Solution

2023-05-30 06:39:26 - last edited 2023-05-30 16:43:22

Hello @Bensch,

You may refer to this FAQ on the official website to set the Mesh network in Standalone mode.

How to configure your EAP access points into a Mesh Network using the Omada App

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

Information

Helpful: 0

Replies: 2

EAP245v3 Mesh in Standalone Mode

EAP245v3 Mesh in Standalone Mode

Information

Voters 0

Tags