Omada OC200 > Wired Networks > LAN Also Gateway
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada OC200 > Wired Networks > LAN Also Gateway
I am a bit confused on the LAN setting in the OC200 Hardware Controller.
I plugged the OC200 into one of the modem / routers ports.
It adopted without issue.
All APs are adopted and connected.
Internet is working.
What exactly is the LAN setting referring to in the Omada Controller?
It shows 192.168.0.1/24. Did it auto-detect my modem because that is the LAN address of the modem or is that a setting I should change so it is different than the modems IP?
The OC200 is obviously getting assigned an IP from the Modem so I am unclear what this setting is and if I need to address it.
When I edit that entry in LAN it has a yellow prompt next to interface that says (Gateway Required).
