lost config of mesh with omada controler
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
lost config of mesh with omada controler
Hello
I did configure a Mesh with 4 EAP Access points at home. The Omada Controler was installed on my computer. This computer crashed and was reset. I've lost all the config of the Mesh
When I install a new Omada controler, I can see 3 of the 4 AP, but I cannot "adopt" them.
the Log entry only say it failed
When I try to connect to the AP directly using the IP address, it is not reachable.
what do you suggest? Reset of all AP?
thank you
Vincent
