LACP between ER7206 and TL-SG2210P

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

LACP between ER7206 and TL-SG2210P

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
LACP between ER7206 and TL-SG2210P
LACP between ER7206 and TL-SG2210P
2022-04-16 19:27:12
Model: ER7206 (TL-ER7206)  
Hardware Version: V1
Firmware Version: 1.1.1 Build 20220117 Rel.59513

Hello,

 

Below is my current setup on Port1 of the switch and LAN1 of the gateway.

I want to create a LACP between them using Port1 (Red) and Port 8 (Yellow) of the switch and LAN1 (Red) and LAN2 (Yellow) of the gateway.

when i create the LAG both switch ports became active as Uplink but the controller looses adoption of ER7206 and all traffic is being dropped.

So i would like to ask is it possible at all to achieve 2Gbps in LAG in my configuration?

 

  1      
  1      
#1
Options
3 Reply
Re:LACP between ER7206 and TL-SG2210P
2022-04-18 05:31:17

Hi  @Krinji 

 

ER7206 does not support LAG/LACP.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:LACP between ER7206 and TL-SG2210P
2022-04-20 17:18:53 - last edited 2022-04-20 17:19:18

  @Hank21 

 

Any idea if LACP will be supported for the ER7206 in the near future? There are some threads on the forum too with this request.

  1  
  1  
#3
Options
Re:LACP between ER7206 and TL-SG2210P
2022-04-20 18:05:47

  @Tha_host in theory should be possible.

 

LACP (LAG) is under the same Linux Bonding Driver that supports Load Balancing .

ER7206 already supports Load Balancing so LACP or at least static LAG should be possible on firmware level.

I've written an email to TP-Link and they'll pass it onto the engineer team for investigation.

  5  
  5  
#4
Options

Information

Helpful: 1

Views: 1640

Replies: 3

Related Articles