CPE210 flashes all lights and PoE flashes red
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
There were internet complaints, I removed the CPE210 from the network and the internet started working again
I removed the antenna, noticed a little oxidation on the connectors, I'm confused about the PoE because the tester doesn't light all the pins, but that doesn't mean anything because I have another PoE working without lighting all the pins, I don't believe the PoE are not the 4 twisted pairs.
Already the voltage is acting correctly from the 24v PoE port
Problem: When power on, CPE LEDs blink together at the same time, 1s in 1s, and PoE LED blinks red, when I take CPE out of PoE, PoE returns to steady green, no LAN signal identified on the computer's ethernet port
The above report started to occur when I tried to reset, before the LED blinked strangely and dimmed
====
Addendum: I took it apart, apparently there is nothing oxidized inside, or wet, I tried using the reset button again, without success, it remains the same
I did an examination with a network tester, got another working CPE, so I made the following comparison:
- PoE injector problem: PoE and LAN port pins are identical to the functional PoE injector
- CPE problem: PoE LAN port pins are identical to functional CPE
In short, the problem CPE doesn't have pins burned by some lightning.
So I plugged in the problem PoE injector into the functional CPE, and it worked well, so the problem PoE injector is fine.
I connected the functional PoE injector on the problem CPE, and the problem continued, crash flashing all the lights.
I suspected it was something in the firmware, so I tried hard reset, it didn't work either.
Here is the CPE open problem, whoever knows how to suggest.
