How to adopt T1600G-28PS to OC200 SDN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to adopt T1600G-28PS to OC200 SDN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to adopt T1600G-28PS to OC200 SDN
How to adopt T1600G-28PS to OC200 SDN
2020-12-01 22:50:21
Hardware Version: V3
Firmware Version: 3.0.5 Build 20200110 Rel.50207(s)

Hello,

 

I have upgraded the fw/sw on my OC200, EAP245v3 and T1600G-28PS to the latest for supporting the SDN setup.

OC200 and EAP245 are working fine and the AP shows up as it should in the controller.

The switch should be supported but I can't find out how to make it show up in the contoller so I can adopt it?

 

Is there someone here to guide me on this?

 

  0      
  0      
#1
Options
2 Reply
Re:How to adopt T1600G-28PS to OC200 SDN
2020-12-02 00:42:07 - last edited 2020-12-02 00:47:48

Dear @Pejtar,

 

The current firmware you get doesn't support SDN setup. You may follow the global link below to check for the firmware upgrade.

https://www.tp-link.com/en/support/download/t1600g-28ps/#Firmware

 

Kind note: when there is a new feature added to a product, we can find it in the release note.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:How to adopt T1600G-28PS to OC200 SDN
2020-12-02 07:45:26 - last edited 2020-12-02 09:35:56

@Fae Many thanks for your reply. Didn't see that fw version yesterday. :-)

Now it works and it looks great.

 

 

Below is a screenshot of my setup. I've played around a little bit and I think this is a good start of a SDN Controller.

  2  
  2  
#3
Options

Information

Helpful: 0

Views: 1151

Replies: 2

Related Articles