Configure R600 as VPN within an existing network?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Configure R600 as VPN within an existing network?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configure R600 as VPN within an existing network?
Configure R600 as VPN within an existing network?
2020-11-17 17:50:36 - last edited 2021-04-18 10:39:16
Model: TL-R600VPN  
Hardware Version: V4
Firmware Version: 4.0.3

Hi, I have an R600 VPN router at site A.  I want to set things up so that a laptop connected at site B can tunnel into site A.  Site A already has a DHCP server in place.  Any ideas on how I can setup the R600 at site A to operate within the existing DHCP network at site A and allow site B access it?

  0      
  0      
#1
Options
1 Reply
Re:Configure R600 as VPN within an existing network?
2020-11-20 10:44:58 - last edited 2021-04-18 10:39:16

Dear @RiverKayaker,

 

Hi, I have an R600 VPN router at site A.  I want to set things up so that a laptop connected at site B can tunnel into site A.  Site A already has a DHCP server in place.  Any ideas on how I can setup the R600 at site A to operate within the existing DHCP network at site A and allow site B access it?

 

Please refer to the guide below to configure L2TP Client-to-LAN VPN on the router.

https://www.tp-link.com/support/faq/2158/

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 570

Replies: 1

Related Articles