EAP245 - Unable to access web based managment when plugged into Trunk port
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I am using Pfsense router + hp procurve 1810 switch with vlans. During initial setup I connected EAP245 AP to vlan60 and assigned 10.0.6.xx as static ip for AP. Then added two SSIDs with vlan50 and vlan60. Then plugged in the AP in trunk port of switch. I could see both SSIDs handing out IPs from vlan50 and vlan60 without issues. But I am unable to access 10.0.6.xx to reach the web management page of AP, even though my laptop is on the same subnet with static IP of 10.0.6.xx.
I tried to setup managment vlan but still won't work. Ping from management vlan returns "host unreachable", but AP continues to work without issues, when plugged in trunk port. Is there anything I am doing wrong?
FYI, pfsense is configured to allow communcations of hosts within vlan60 in 10.0.6.xx.
In summary, when connected to trunk port, I am unable to access web managed using AP's IP 10.0.6.xx. But when i plug the AP into access port of vlan60, I am able to access webgui
I have been struggling with this issue for almost a week now. Any help is appreciated greatly.
