This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi there,
Is it possible to configure R480T+, any of the interfaces as WAN and LAN using 802.11q. Please, have a look on the scheme:
The VLAN config is OK, I have connectivity in vlan20 and vlan1, but R480T+ GUI does not allow to set WAN interface in the vlan10.
Any help will be much appreciated!
Please note that R480T+ uses VLAN to isolate WAN and LAN. So the WAN port and LAN port cannot belong to the same VLAN. So in your topology, you cannot make port1 and port5 of R480T+ belong to VLAN20 at the same time.
Actually I don't know why you want to make local computer connect to WAN port. Maybe you can tell the reason then we can find other function to meet your requirement.
Please note that R480T+ uses VLAN to isolate WAN and LAN. So the WAN port and LAN port cannot belong to the same VLAN. So in your topology, you cannot make port1 and port5 of R480T+ belong to VLAN20 at the same time.
Actually I don't know why you want to make local computer connect to WAN port. Maybe you can tell the reason then we can find other function to meet your requirement.
Helpful: 0
Views: 1037
Replies: 1
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.