CONFIGURE VPN OVER ROUTER AND LOAD BALANCER TL-R480T +

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CONFIGURE VPN OVER ROUTER AND LOAD BALANCER TL-R480T +

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CONFIGURE VPN OVER ROUTER AND LOAD BALANCER TL-R480T +
CONFIGURE VPN OVER ROUTER AND LOAD BALANCER TL-R480T +
2020-10-20 08:37:27 - last edited 2021-04-18 10:48:45
Model: TL-R480T+  
Hardware Version: V4
Firmware Version:

Hello, please give me a hand with the following.

 

I need to connect via VPN to the home office server, the topology shows a load balancer between the router and the LAN switch, I can connect via VPN to router 1, I can PING to its IP (192.168. 2.1) and I have an answer, however, it has from there onwards (192.168.10.1, 192.168.10.100, 192.168.10.10, etc), towards the LAN, I have no answer.

 

The following is the topology

 

Thanks in advance.

 

  0      
  0      
#1
Options
1 Reply
Re:CONFIGURE VPN OVER ROUTER AND LOAD BALANCER TL-R480T +
2020-10-21 09:35:22 - last edited 2021-04-18 10:48:45

Dear @PFS_ENZZO,

 

The TL-R480T+ is a NAT device in your network, which blocks the devices to communicate with the LAN devices behind the TL-R480T+.

 

To connect the server 192.168.10.10, it's suggested to set up a site to site IPSec VPN between the home router and TL-R480T+ Router.

 

Note: please go to Firewall > Attack Defense to uncheck "Block Ping from WAN" before you try to ping the WAN of TL-R480T+ Router.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 3189

Replies: 1

Related Articles