Help restore my TP link CPE 210 V1.1 to its original Tplink firmware
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello, about a year ago I installed the Firmware of LEDE version 18 on my Tplink CPE210, and I was using my antenna without difficulty, now a few days ago I decided to restore it with its original Firmware.
I did it step by step through this link
https://www.tp-link.com/fr-be/support/faq/844/
https://oldwiki.archive.openwrt.org/toh/tp-link/tl-cpe210#debricking
But the antenna now I can not access the web, nor do I have ping 192.168.0.254. is dead.
The process seems to me that everything is going well.
I downloaded the 3 Firmware available on the original tplink site and tested each one of them and it still doesn't work
The method I used was Tftp:
This is the Tftp log:
Connection received from 192.168.0.254 on port 4011 [04/17 19: 29: 52.500]
Read request for file <recovery.bin>. Mode octet [04/17 19: 29: 52,500]
OACK: <timeout = 5, blksize = 512,> [04/17 19: 29: 52.500]
Using local port 53429 [04/17 19: 29: 52,500]
<recovery.bin>: sent 8731 blks, 4470235 bytes in 2 s. 0 blk resent [04/17 19: 29: 54.890]
The process seems to be going well. Load the Firmware, then turn on all the LEDs. They turn off and only the power stays on and in about 15 seconds LAN0 turns on and does nothing more.
Could you tell me if I am making a mistake in the process?
How can I install the original Tplink Firmware?
In case you can't install your original software, how could you install LEDE again as a last resort?
I am grateful in advance for any help you can give me to recover my antenna.
Sincerely
Ivan
