need some help configuring TL-SG105E vlans
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
need some help configuring TL-SG105E vlans
Model :
Hardware Version :
Firmware Version :
ISP :
Hello All,
I have a fiber line coming to my house(dhcp over vlan 35 with 5 external IPs) that is connected to a tp-link MC220L media converter. When I connect that directly to my pfsense router and set my wan to use vlan 35, I get an IP and everything works fine. I am now trying to connect the MC220L to a TL-SG105E smart switch using port 1, port 2 goes to 1st pfsense and the 3rd port goes to a second pfsense. However, with this configuration, pfsense can't get any ips so I assume I don't have my vlans right.
Can someone have a look at my SG105E UI config and tell me where i went wrong?
TL-SG105E
Port 1 = MC220L fiber line
Port 2 = pfsense 1 vlan 35
Port 3 = pfsense 2 vlan 35
TL-SG105E
[/TD]
[/TR]
[/TABLE]
Hardware Version :
Firmware Version :
ISP :
Hello All,
I have a fiber line coming to my house(dhcp over vlan 35 with 5 external IPs) that is connected to a tp-link MC220L media converter. When I connect that directly to my pfsense router and set my wan to use vlan 35, I get an IP and everything works fine. I am now trying to connect the MC220L to a TL-SG105E smart switch using port 1, port 2 goes to 1st pfsense and the 3rd port goes to a second pfsense. However, with this configuration, pfsense can't get any ips so I assume I don't have my vlans right.
Can someone have a look at my SG105E UI config and tell me where i went wrong?
TL-SG105E
Port 1 = MC220L fiber line
Port 2 = pfsense 1 vlan 35
Port 3 = pfsense 2 vlan 35
TL-SG105E
| 802.1Q VLAN Configuration: (all the other vlan tabs are default disabled) [TABLE="class: BORDER"] |
||||
| VLAN Name | Member Ports | Tagged Ports | Untagged Ports | Delete |
| 1 | Default_VLAN | 1-5 | [/TD] [TD]1-5 |
[/TD] |
| BELL_ISP | 1-3 | 1-3 | [/TD] [TD] |
[/TD]
[/TR]
[/TABLE]
