Connection 2 TL-SG1024DE and passing VLANs
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Connection 2 TL-SG1024DE and passing VLANs
Model :
Hardware Version :
Firmware Version :
ISP :
I have 2 TL-SG1024DE swtiches. Each has 18 802.1Q VLANs running fine per switch. 18 ports, each with a different VLAN assigned to it. I had to physically reconfigure some things, so now I have one of the switches cascaded from the other. I cannot figure out how to get the VLANs to pass from the 1st switch to the 2nd. I have a Ubiquiti Edgerouter Lite then to the 1st switch and then 1st switch out to switch 2. Passing traffic fine, just not the VLANs, so am not getting the VLAN IPs on 2nd switch. Any port that should be getting one of the VLAN IPs, instead gets the normal LAN IP. There are a total of 36 VLANs. 18 on 1 st switch, 2nd 18 on the 2nd switch.
Switch 1 port 24 goes to Edgerouter.
Switch 1 port 23 goes to Switch 2 port 24.
I'm really unsure of how to get the VLANs to pass to switch 2. Is this possible? I would think that it is, I'm just not as knowledgeable about VLANs and tagging/untagging etc as I'd like to be. If not possible, could I place an unmanaged switch after the router, then out of that to each TL-SG1024DE and maintain my VLAN setup?
Hope that all makes sense.
Thanks in advance for any help.
Hardware Version :
Firmware Version :
ISP :
I have 2 TL-SG1024DE swtiches. Each has 18 802.1Q VLANs running fine per switch. 18 ports, each with a different VLAN assigned to it. I had to physically reconfigure some things, so now I have one of the switches cascaded from the other. I cannot figure out how to get the VLANs to pass from the 1st switch to the 2nd. I have a Ubiquiti Edgerouter Lite then to the 1st switch and then 1st switch out to switch 2. Passing traffic fine, just not the VLANs, so am not getting the VLAN IPs on 2nd switch. Any port that should be getting one of the VLAN IPs, instead gets the normal LAN IP. There are a total of 36 VLANs. 18 on 1 st switch, 2nd 18 on the 2nd switch.
Switch 1 port 24 goes to Edgerouter.
Switch 1 port 23 goes to Switch 2 port 24.
I'm really unsure of how to get the VLANs to pass to switch 2. Is this possible? I would think that it is, I'm just not as knowledgeable about VLANs and tagging/untagging etc as I'd like to be. If not possible, could I place an unmanaged switch after the router, then out of that to each TL-SG1024DE and maintain my VLAN setup?
Hope that all makes sense.
Thanks in advance for any help.
