TL-SG1016DE, conflict w/ VDSL router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG1016DE, conflict w/ VDSL router
Model :
Hardware Version :
Firmware Version :
ISP :
Hi all,
I am aiming to use a TL-SG1016DE to enlarge my home network as the VDSL router (O2 Homebox 6641, a re-branded Zyxel) has only 4 RJ45 ports.
I am asking you for help with solving a conflict between switch and router.
Once the switch is plugged into the router, all internet and network access crashes (also after switch factory re-set).
Router:
Internet access when directly plugging into the VDSL router works fine with router DHCP activated.
The router is set to use the 192.168. 1.x range, itself w/ 192.168.1.1.
Also no problem if I manually change it to use the 192.168. 0.x range.
Switch
I can directly access the router via 192.168.0.1 once the IP4 on my Win10 PC is manually set to some IP in the identical subnet 255.255.255.0.
If the static IP is changed, also no problems to access later directly.
Now the problem:
However, in order to accommodate the router DHCP, I logged on and activated DHCP.
After that, I can no longer access it directly (except for after a factory reset).
Now, If I plug the switch into the router, all traffic crashed, the router itself is also no longer reachable, neither is internet.
What am I doing wrong?
Can someone help?
Kind regards
andym
Hardware Version :
Firmware Version :
ISP :
Hi all,
I am aiming to use a TL-SG1016DE to enlarge my home network as the VDSL router (O2 Homebox 6641, a re-branded Zyxel) has only 4 RJ45 ports.
I am asking you for help with solving a conflict between switch and router.
Once the switch is plugged into the router, all internet and network access crashes (also after switch factory re-set).
Router:
Internet access when directly plugging into the VDSL router works fine with router DHCP activated.
The router is set to use the 192.168. 1.x range, itself w/ 192.168.1.1.
Also no problem if I manually change it to use the 192.168. 0.x range.
Switch
I can directly access the router via 192.168.0.1 once the IP4 on my Win10 PC is manually set to some IP in the identical subnet 255.255.255.0.
If the static IP is changed, also no problems to access later directly.
Now the problem:
However, in order to accommodate the router DHCP, I logged on and activated DHCP.
After that, I can no longer access it directly (except for after a factory reset).
Now, If I plug the switch into the router, all traffic crashed, the router itself is also no longer reachable, neither is internet.
What am I doing wrong?
Can someone help?
Kind regards
andym
