Windows EAP Controller and firewall
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Windows EAP Controller and firewall
Model :
Hardware Version :
Firmware Version :
ISP :
Hi there,
Just need a general advice on how to configure a windows-based firewall when using EAP Controller (v2.4.8).
What happened was ... I had McAfee LiveSafe installed and noticed that EAP Controller always failed to adopt my EAP120, it always says RETRY (I've tried to restore the AP to factory default and manually add admin/admin on the RETRY box but no luck).
So I've disabled McAfee LiveSafe firewall and it works!
Next I uninstalled McAfee LiveSafe and FORGET AP.
With only Windows Firewall default settings, I re-tried the adoption process again.
This time it works.
I don't know what's the difference between them but I guess there's some tricks to it.
What program/port required to be open inbound/outbound for a (Windows-based) normal EAP Controller operation to works?
Thank you.
Hardware Version :
Firmware Version :
ISP :
Hi there,
Just need a general advice on how to configure a windows-based firewall when using EAP Controller (v2.4.8).
What happened was ... I had McAfee LiveSafe installed and noticed that EAP Controller always failed to adopt my EAP120, it always says RETRY (I've tried to restore the AP to factory default and manually add admin/admin on the RETRY box but no luck).
So I've disabled McAfee LiveSafe firewall and it works!
Next I uninstalled McAfee LiveSafe and FORGET AP.
With only Windows Firewall default settings, I re-tried the adoption process again.
This time it works.
I don't know what's the difference between them but I guess there's some tricks to it.
What program/port required to be open inbound/outbound for a (Windows-based) normal EAP Controller operation to works?
Thank you.
