PORT isolation stopped work - Omada SW controller
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
first i try port isolation future and it work.
After that, i try setup some VLANs on network with OMADA software Controller.
VLAN works, but i decide to return to configuration without VLAN and use PORT ISOLATION, so i switch to default PORT configuration (LAN1).
After removing all my "custom" vlan settings, PORT ISOLATION not work. So Port with isolation turned on, can see other isolated ports.
What i set wrong, when remove all custom vlans? Where is problem?
First, this is about Omada controller windows, not switch. So sorry for this.
So, for all ports set port profile to LAN1 (default profile, not editable). Have assigned VLAN1 by default.
1. set Port Isolation on two ports on 2 switch devices
2. connect to these ports 2 PCs
3. normally, this 2 PCs cant ping or RDP to each other. But, i CAN.
I sended some pictures about my config:
