Hi  @Rapid 

You can disable mesh site-wide.  Open the site, navigate to Settings->Site Settings(General Settings), Scoll Down to Wireless Features->Enable and un-check it.

Hi!  @D-C !

I don't want to disable mesh. I set it up, because I need it.

I want to disable the function when a wired AP connects to the other AP through wireless connection to maintain the mesh system when the wired connection fails or I would like to see a firmware update for the EAP225-Outdoor, so it would turn off the wireless connection when the wired connection reestablished.

My network is malfunctioning and needs manual intervention when the wired connection of the EAP225-Outdoor fails for any reason then reestablished.

The problem appeared when the switch connecting the EAP225-Outdoor to the network through wired connection lost power for around 10-15 minutes and then powered back up.

The second time when this happened took me 2 hours to rule out every other device in my network and the loopback caused network-wide connection failures.

First time I just unplugged/replugged every device at once, because I didn't have the time to debug my entire network.