@Berg-UA 

if you don't have any deny rules, all the rules you have defined are ineffective, you have created rules that are already there by default.

remove all the acl rules, they have no effect

  @MR.S  uhh ... I removed them all and it didn't help - still getting Adoption Loop

Also I have static routes 

I'm already starting to regret investing money in this "business" platform, this is the third time in six months I've had the same problem with this ER605 and it just crashes out of the blue even if I restore the previous settings

  @Berg-UA 

remove the routes too, there is no need to route between vlans

  @Berg-UA 

All the settings you have set are saved in the router. If you are still having problems, it may be that the router is unable to read the settings from the controller due to these settings. The solution is to factory reset the router and re-adopter.

  @MR.S  ok,  after removing routes adopted success, but ... it worked with routes before  I tried to add 3-rd ACL rule ...  

today I reset my router at least 10 times  ))))
ok, and how I can get access from 192.168.111.0/24 (wifi) to 192.168.20.0/24 (cameras)? 
how mobile app Hik-connect can get access to my cameras in 192.168.20.0/24 ? 

it not working now without routes 

  @Berg-UA 

hard to say what you have configured. but check switch acl and eap acl.

  @MR.S  I don't have any configurations ... only two VLANs and  reset the router and adopted as 192.168.111.1 as dhcp-server and that it
all routes and ACLs were removed  

  @Berg-UA 

ok, yes then I don't know, but you shouldn't add a route or create any acl to communicate between vlans, it's open by default. try pinging router gateway on remote vlan, do you get a response to ping?

  @Berg-UA 

but show me a screenshot of how you have configured vlan

  @MR.S List

Default Details 

Cameras details