Hi Everyone,

I have an issue, I recently upgraded my switch from a TL-SG3428MP to a SG3428XPP-M2. I have an old network device that only runs at 10/Half Duplex, it will auto negotiate this but for some reason the link goes up and down and its fairly unreliable.

On the old switch I could force this port to 10/Half in the Omada GUI and it worked fine, on the new SG3428XPP-M2 this is not an option in the GUI the minimum it allows you to set is 100/Half Duplex.

So I have tried setting it in the CLI overrides using the speed 10 command but this wont apply, I get the error:

Command "speed 10"(line 4) failed to execute.

Is this a bug or is it just not possible to set on this device? anyone have any other ideas how I can resolve this other than add another switch that I can set this on?