some 5GHz channels not available / reg domain
Hi,
I'm new to the community and new to TPLink so sorry if I get the protocol wrong.
I was trying to set the channels for 5GHz in particular and can not see the higher ones (i.e. 149).
If you SSH onto the AP, iw shows the reg as DE but even DE should be able to see those channels. My other concern is in New Zealand channels 100 and up can use higher power and 149 and up even higher.
Even switching from 36 to 100 doesn't see any increase in signal strength on the client, which I would have expected. The AP is running on an external power supply rather than PoE as that seemed to improve 6GHz signal.
So I guess my questions are can you set the reg domain to access those channels? Will they use the extra power allowed if you do select them?
Thanks
Nick
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Thanks for the help. Appreciate the guidance.
I'll post an update once we have it sorted in case other people search for the same issue.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
When setting up a 5G access point, the channels you can use will depend on the specific frequency bands supported by your 5G equipment and the regulations in your region. TP-Link TP's APs strictly adhere to each country's wireless regulations. To determine the specific channels you can use, consult local regulatory authorities for guidance on channel selection in your region. It's also a good practice to perform a site survey to assess the wireless environment and optimize channel selection for performance and reliability.
- Copy Link
- Report Inappropriate Content
Thanks for following up.
I guess that was kind of my question. I'm in New Zealand, but the AP looks to be set for Germany, is there some way in the Omada software to set the county code to New Zealand so I can access the correct channels?
Thanks,
Nick
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
and this is my iw scan..
(on wlp2s0) -- associated
last seen: 1934.253s [boottime]
TSF: 419851408839 usec (4d, 20:37:31)
freq: 5500.0
beacon interval: 100 TUs
capability: ESS Privacy SpectrumMgmt ShortSlotTime (0x0511)
signal: -53.00 dBm
last seen: 33 ms ago
Information elements from Probe Response frame:
SSID: MySSID
Supported rates: 6.0* 9.0 12.0* 18.0 24.0* 36.0 48.0 54.0
Country: DE Environment: Indoor/Outdoor
Channels [36 - 64] @ 23 dBm
Channels [100 - 140] @ 30 dBm
Power constraint: 0 dB
TPC report: TX power: 25 dBm
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi,
It's managed via omada. Same account as this one of you can see the email etc
Thanks,
Nick
- Copy Link
- Report Inappropriate Content
Hi @NickBNZ
We won't be able to view your controller based on your email address.
I created a support ticket for you; please check your email inbox by the case ID TKID241159142
- Copy Link
- Report Inappropriate Content
Thanks for the help. Appreciate the guidance.
I'll post an update once we have it sorted in case other people search for the same issue.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 310
Replies: 10
Voters 0
No one has voted for it yet.