Home

Forums

Stories

Knowledge Base

Business Community > Pharos Wireless Bridges > Not able to connect BETWEEN 2 cpe ANTANA

< Pharos Wireless Bridges

Not able to connect BETWEEN 2 cpe ANTANA

wolf98

2024-11-17 08:32:20 - last edited 2024-11-18 08:07:50

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-09-30

Not able to connect BETWEEN 2 cpe ANTANA

2024-11-17 08:32:20 - last edited 2024-11-18 08:07:50

Tags: #Outdoor Wi-Fi Solution

Model: CPE510 CPE610

Hardware Version: V7

Firmware Version:

configured everything properly in my PC within the Room and Placed the Astana in my 2 nd Floor roof and my Client is nearly 1.5km Distance after that I installed the Client in 20 feet Height and tried to connect the internet But the signal is Not showing in the Client it self

Kindly help me to resolve the issue

Notew: is really need to see the antana from my Client side..? by Human Eyes, also

1 Accepted Solution

Vincent-TP

2024-11-18 08:06:47 - last edited 2024-11-18 08:07:50

Posts: 1151

Helpful: 117

Solutions: 439

Stories: 0

Registered: 2024-06-22

Re:Not able to connect BETWEEN 2 cpe ANTANA-Solution

2024-11-18 08:06:47 - last edited 2024-11-18 08:07:50

Hi @wolf98

You may first bring the client CPE close to the access point EAP, and refer to the following guide to link the two units:

How can I set up the AP + Client topology successfully?

After you successfully configured the client CPE, you can install it on the second point.

For the distance, you may configure the distance setting as 1.6 km.

Recommended Solution

1 Reply

Vincent-TP

2024-11-18 08:06:47 - last edited 2024-11-18 08:07:50

Posts: 1151

Helpful: 117

Solutions: 439

Stories: 0

Registered: 2024-06-22

Re:Not able to connect BETWEEN 2 cpe ANTANA-Solution

2024-11-18 08:06:47 - last edited 2024-11-18 08:07:50

Hi @wolf98

You may first bring the client CPE close to the access point EAP, and refer to the following guide to link the two units:

How can I set up the AP + Client topology successfully?

After you successfully configured the client CPE, you can install it on the second point.

For the distance, you may configure the distance setting as 1.6 km.

Not able to connect BETWEEN 2 cpe ANTANA

Not able to connect BETWEEN 2 cpe ANTANA

Information

Voters 0

Tags