Omada ER605 LINK BACKUP confuses primary WAN and Backup WAN
Hi
I have two WAN interfaces. and my new ER605 ALWAYS use backup WAN (100mbs) as Primary WAN and my Primary WAN (1000gbps) is not used it is resting all the time
Whats happening? Load balance disabled. all outgoing traffic goes through backup WAN. speedtest and my ip shows backup isp
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @YuriyB
Thanks for posting in our business forum.
In the configuration guide, we have clearly instructed you to enable the load balancing if you need link backup. You did not enable it at all and of course, the system did not function properly.
https://www.tp-link.com/en/support/faq/2133/
- Copy Link
- Report Inappropriate Content
my two PPTP Clients are using WAN (Primary) and connections established i can see it on server side ( shows my PRIMARY WAN IP)
but all another traffic goes through backup WAN2
tp-link did u test it??
- Copy Link
- Report Inappropriate Content
Hi @YuriyB
Thanks for posting in our business forum.
In the configuration guide, we have clearly instructed you to enable the load balancing if you need link backup. You did not enable it at all and of course, the system did not function properly.
https://www.tp-link.com/en/support/faq/2133/
- Copy Link
- Report Inappropriate Content
@Clive_A ticket closed. thank you
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 405
Replies: 3
Voters 0
No one has voted for it yet.