weak connection

weak connection

weak connection
weak connection
2024-08-05 23:15:58 - last edited 2024-08-15 08:36:04
Model: EAP225-Outdoor  
Hardware Version: V3
Firmware Version: 5.1.0 Build 20220926 Rel. 62456

I am attempting to control a building approximately 70 yards from my EAP225 single access point unit.  I want to control 2 switches, two plugs, and one wyze camera out there and one camera 80 degrees from them with no obstructions.  I have tried a tp CPE210, an AV600 power link, and  Edimax extenders.  This EAP225 gave me some hope,  Unfortunally the signal is weak and unstable.  To add to my struggles I changed my internet carrier from Spectrum to T-Mobile to increase my speed,  There may be some network conflicts that need to be resolved, not sure.  I have read conflicting information on the placement of this unit, High or low from the ground.  I am open to any suggestions, PLEASE.

  0      
  0      
#1
Options
1 Accepted Solution
Re:weak connection-Solution
2024-08-06 03:42:08 - last edited 2024-08-15 08:36:04

Hi  @dq21 

 

70 yards is too far for normal switches or plugs. 

You can install the EAP215 bridge KIT instead.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:weak connection-Solution
2024-08-06 03:42:08 - last edited 2024-08-15 08:36:04

Hi  @dq21 

 

70 yards is too far for normal switches or plugs. 

You can install the EAP215 bridge KIT instead.

Recommended Solution
  0  
  0  
#2
Options