Adoption Omada controller
Hi all, so i have an AP EAP610 which is branched directly to the router via a Ethernet cable, the AP take the parameters from the router and everything is going well.
I want to control my APs , switchs and routers from Omada controller v5.14.20.9 so I've obliged to adopt this devices. Every device in the network is adopted successfully, but the EAP610 failed to adopt.
I tried to update the firmware version, to connect directly to the device with cable, reset and try another time ...
Any help ..
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I believe I find the reason.
The controller PC is connecting to the EAP's wifi when trying to adopt the EAP, right?
When the EAP turns to Provisioning status, the controller will try to assign the controller's WLAN settings to the EAP, and the EAP's own/default SSID will be cleared.
During this process, the PC will lose the connection with this network since the EAP's SSID does not exist anymore.
Solution:
Connect the PC to your main router's wifi, or wired connecting to the network.
- Copy Link
- Report Inappropriate Content
@ghost124 Have you tried to adopt it connected to a different source? Is it getting power? Did you try different ports on the router?
- Copy Link
- Report Inappropriate Content
Hi @ghost124
If the Omada devices are showing as "pending" on the controller but fail to be adopted, you can follow these steps to troubleshoot the issue:
1. Pay attention to any error messages that appear when you click the "Adopt" button. Here are some common errors and their solutions:
a) "The Username or Password is incorrect": Check if the default username/password of the Omada device (usually admin/admin) has been changed. If you have forgotten the credentials, you can reset the device by pressing the reset button.
b) "Device adoption failed because the device does not respond to adopt commands": This error indicates a communication issue between the EAP (Omada device) and the Omada Software Controller/Hardware Controller. Ensure that TCP/UDP ports 29810-29814 are open in any antivirus or firewall settings.
2. Update the firmware of the devices.
3. Try to reset the device and restart the controller.
For more detailed guide, please refer to this link: What to do if Omada Device Adoption Failure
- Copy Link
- Report Inappropriate Content
Thank u for ur response,
I tried with ping and the communication between the software controller and the device is succeed.
The problem is when i click adopt, it's moving from PENDING>ADOPTING>PROVISIONING then everything is destroyed (the internet cutting off, both WIFI of the EAP610 does not appears in the PC). So every time I do reset the devise nd reconfigure it from the begging.
Like it shown in the captures
I hope it's clear
thank you.
- Copy Link
- Report Inappropriate Content
I believe I find the reason.
The controller PC is connecting to the EAP's wifi when trying to adopt the EAP, right?
When the EAP turns to Provisioning status, the controller will try to assign the controller's WLAN settings to the EAP, and the EAP's own/default SSID will be cleared.
During this process, the PC will lose the connection with this network since the EAP's SSID does not exist anymore.
Solution:
Connect the PC to your main router's wifi, or wired connecting to the network.
- Copy Link
- Report Inappropriate Content
@Vincent-TP Thanks, the problème was solved nd the devise connected to the manager, but the wifi doesn't appear in the wifi list.
Thank u again
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 485
Replies: 6
Voters 0
No one has voted for it yet.