Hi @Gurky
Thanks for posting in our business forum.
Gurky wrote
@Clive_A Firmware upgrade failure would happen if the power/cable is disconnected during the upgrade.
That is absolutely not true, as I didn't touch then during the process. And I've seen a huge number of this same issue so it seems to be a huge TP-link issue. Put me off doing my whole home with Tapo I now have to find an alternative.
3. About the 100M vs 1000M, I would still say it is a cable issue. Length and quality should be both considered. If you make the cable, I'd recommend you get a commercial one and test it out. Or you can run the same cable to the switch and make a loop to see if it 1000M. If not, that tells you the cable is not good.
That's a good shout I didn't think of actually, not doable in the space but an idea of the future! Also issue is I couldn't access the managed switch UI to see the speeds.
I did manage to fix my issue with the switch following the below:
https://community.tp-link.com/en/business/forum/topic/77562
It didn't help that the reset button also didn't work
It is just two sides of a thing. You have failed or succeeded in the firmware upgrade. Either way, you would not ask if you succeeded in upgrading it.
People come to support or forum because they have an issue with it. You only see the other side. Survivorship bias.
I don't receive an increasing number of cases in easy smart models about firmware upgrade failure. I looked it up in the support system, likewise, in a month, no sign of any reports like yours.
That was a post I came across before. I am not sure if it would even be for your V6. If it works, then I guess the system does not change too much. Chipset plan should be the same as the old one or very similar.
About the cable, believe it or not, search on the forum, and you will see many resolved by changing the cables. The switch sometimes would not work well with some cables. Tedious suggestion from me or support but it works.
Reset button did not work, I recommend you contact the support and tell them on the line what you see during the process you perform a reset. You probably need to go through the RMA process.