Combine eap225 & eap660
Hello,
I have 2 EAP225 connected with MESH with a software omada controller. I have purchased 2 EAP660 AX3600, and I need to connect them at the same MESH network. Is that possible?
How can I make that happen?
Thank you
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
upgrade to controller 5.13 and access point firmware is EAP225(EU)_V3_5.1.1 Build 20230921
I this is eu if you are in other region you find your software on locak tp-link site
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
WooW 3.2 no thats nok ok, you have to upgrade controller :-) but your v3 EAP225 is supported with new controller but need new firmware :-)
- Copy Link
- Report Inappropriate Content
i tried to upgrade controller to 4.5 , but the backup from 3.2.17 is not working. So I have to re configure the controller...
do you know which firmware and software should update?
thank you!
- Copy Link
- Report Inappropriate Content
upgrade to controller 5.13 and access point firmware is EAP225(EU)_V3_5.1.1 Build 20230921
I this is eu if you are in other region you find your software on locak tp-link site
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
As I remeber it should work, its many many years last time I do this upgrade :-)
take backup of everything before start then you have option to go back.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 628
Replies: 10
Voters 0
No one has voted for it yet.