ER7206 IPSEC Site-to-Site - no incoming traffic

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER7206 IPSEC Site-to-Site - no incoming traffic

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

eightball

2023-11-07 02:17:37 - last edited 2023-11-16 06:10:43

Posts: 8

Helpful: 0

Solutions: 1

Stories: 0

Registered: 2023-11-07

ER7206 IPSEC Site-to-Site - no incoming traffic

2023-11-07 02:17:37 - last edited 2023-11-16 06:10:43

Tags: #VPN

Model: ER7206 (TL-ER7206)

Hardware Version: V1

Firmware Version: 1.2.3 Build 20221104 Rel.41500

Hi,

I have just set up a new ipsec site-to-site tunnel to a remote Edgerouter ER4. I can initiate outgoing traffic without issue. I cannot however receive traffic initated at the remote end. I have tried disabling all firewall default settings I could find. Are there any other things I should check?

Note that this is a dual WAN setup if that makes any difference. The tunnel is setup to use WAN1 on the ER7206.

1 Accepted Solution

eightball

LV1

2023-11-07 02:55:56 - last edited 2023-11-07 08:24:39

Posts: 8

Helpful: 0

Solutions: 1

Stories: 0

Registered: 2023-11-07

Re:ER7206 IPSEC Site-to-Site - no incoming traffic-Solution

2023-11-07 02:55:56 - last edited 2023-11-07 08:24:39

disregard, the solution to this was a simple reboot. Always a bit odd why it's required when things worked in one direction, but at least it appears solved.

Information

Helpful: 0

Replies: 1

ER7206 IPSEC Site-to-Site - no incoming traffic

ER7206 IPSEC Site-to-Site - no incoming traffic

Information

Voters 0

Tags