Exposing my port 80 and 443 via the Omada Software Controller for hosting Nginx reverse proxy
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Exposing my port 80 and 443 via the Omada Software Controller for hosting Nginx reverse proxy
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I am writing on this forum for the first time in hope that someone will be able to help me with my problem.
I am using a Omada Software Controller where my
- Router ER-605
- Switches TL-SG2210P v3.20
- Access EAP245
are all managed by the Omada Software Controller connected to one of the switches as in point 02.
I am trying to deploy Nginix Reverse Proxy via npm and when i try to expose port 80 and 443 on the Router, the traffic lands on the router's login page instead of the portfording rule that I have defined under Settings > Transmission > NAT > Portforwarding rules.
These rules to route the traffic to a dedicated system inmy network are not working at all and the traffic lands an the login page of the router with the message in the red at the bottom saying "This Gateway is managed by Omada Controller <IP address>
Can any one help me fis this issue?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Can you share your discord id, would love to understand a solution to this problem
GodlikeROOT wrote
This can be done. I am doing it now. ER707-m2 Software controller Many switches and AP Maybe you hit me up on Discord or something and I can talk to you about it.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2084
Replies: 13
Voters 0
No one has voted for it yet.