AP IS HAVING MORE ISOLATED ISSUE
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
HI GUYS, WHAT DO YOU THINK IS THE ROOT OF THIS PROBLEM, IM GETTING MORE AND MORE ERROR ABOUT MY AP GETTING ISOLATED. AT FIRST IT WAS OK UNTIL 2 DAYS AGO IM HAVING THIS AND MY CLIENTS ARE UPSET PLEASE HELP
If the Mesh signal is weak or suffering interference then either of these will cause the isolation issue. I noticed a degradation in the mesh backhaul when it's very humid or there is active precipitation. Of course, somebody may have just fired up a new device (or an old one changed channels) and now you have a lot more local noise around the problem AP. Flaky power (maybe swap POE injectors and calbes between units and see if problem moves?), overheating can also cause 'isolations'.
Are you using a 5.8G channel that supports maximum power in your geographic region?
What does the signal strength look like? Here's a pretty happy meshed node on my network (low usage right now due to holiday/TOD)
If the Mesh signal is weak or suffering interference then either of these will cause the isolation issue. I noticed a degradation in the mesh backhaul when it's very humid or there is active precipitation. Of course, somebody may have just fired up a new device (or an old one changed channels) and now you have a lot more local noise around the problem AP. Flaky power (maybe swap POE injectors and calbes between units and see if problem moves?), overheating can also cause 'isolations'.
Are you using a 5.8G channel that supports maximum power in your geographic region?
What does the signal strength look like? Here's a pretty happy meshed node on my network (low usage right now due to holiday/TOD)