Install beta firmware
Hello everyone. I'm trying to install the beta firmware 1.0.4 on my ER8411 to address my issues with the OpenVPN client, but I'm encountering an error when I upload the file. I don't think it's due to disk space, as I still have 50% left.
Can anyone help me?
I wanted to perform this update because I am unable to configure the OpenVPN client.
Thanks
Matthieu
P.S. : I work with OC200 hardware.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
If you have a hardware controller, it can only be installed stand alone, with a software controller it should work if you have 5.9 or newer
as for OpenVPN, it is not fixed in 1.0.4
- Copy Link
- Report Inappropriate Content
If you have a hardware controller, it can only be installed stand alone, with a software controller it should work if you have 5.9 or newer
as for OpenVPN, it is not fixed in 1.0.4
- Copy Link
- Report Inappropriate Content
Thank you, I just understood. Since I'm on an OC200 hardware, I can't install this beta yet :-(
- Copy Link
- Report Inappropriate Content
I edit my post, There is no beta to OC200 so you hae to remove router from controller and install in stand alone, then readopt router after upgrade to 1.0.4
- Copy Link
- Report Inappropriate Content
But that will not heltp you with OpenVPN problem, this is steel unfixed,
but there are many new features that make it a good upgrade anyway
- Copy Link
- Report Inappropriate Content
Just a little tip for the OpenVPN problem, if you can use TCP instead of UDP it will work, it's very slow but it works.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 709
Replies: 5
Voters 0
No one has voted for it yet.