Should i buy an new EAP245 or better EAP610

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Should i buy an new EAP245 or better EAP610

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Should i buy an new EAP245 or better EAP610
Should i buy an new EAP245 or better EAP610
2023-05-06 11:15:13
Model: EAP245  
Hardware Version:
Firmware Version:

Hello,

During the conversion, an EAP245 unfortunately broke.

Now I am considering buying a new EAP245, because it worked perfectly.

An alternative would be an EAP610 with WiFi6 support. But I have clients that don't support Wifi6 or WPA3. So I would have to disable that on the EAP610 then the EAP610 would have no advantage over an EAP245, would it? It would just be more future-proof at some point with Wifi 6.

 

Have seen, the EAP610 has fewer antennas and I can't also use Wifi6,

Would the EAP610 still have advantages?
Would the EAP610 have the same or better range than the EAP245?

 

Maybe someone has experience?
Thanks :)

  0      
  0      
#1
Options
1 Reply
Re:Should i buy an new EAP245 or better EAP610
2023-05-06 15:05:14

  @lukass2000 

 

My decision for this would be based on the clients your currently have, namely the 2x2 or 3x3 clients.  The EAP245 can handle 3x3 connections whereas the EAP610 is a 2x2 so may result in a speed drop if you have 3x3 clients.

 

The way to check this, see if any of your current clients are connected via WiFi with a speed greater than 866mbps (2x 433mbps)  which is the max speed of an AC 2x2 card.  To be honest, its highly likely your devices are all 2x2, only ever seen a 3x3 when specifically bought for that reason. 

 

If that is the case, then there are likely to be no issues with performance running your existing devices, and the addition of WiFi6 would be good future-proof. 

 

In terms of running WPA2 and 3 co-current.   In the controller you can select WPA3 SAE with WPA2 AES in a mixed mode, or just stick to WPA2.

 

Hardware wise, the EAP610 being a newer AP, there is a definite chance this will be supported longer going forward, where as the AC hardware is likely becoming end of life.

 

 

 

  0  
  0  
#2
Options