OC200 adoption and busy issues
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
Set up a oc200 controller today with my sky broadband router 4 access points (3 x EAP225, 1 x EAP245)
Also have 2 x 5Port POE switches (TL-SG1005P) in my home network fed from the sky router.
Problem is one of the EAP225 just won't adopt (Adopt Failed) to the the controller (the other 3 AP's are ok),
i've had to set it up as a stand alone with the same SSID and password,
but really want to have all four AP's linked to the oc200 controller for cloud remote access.
I've tried another new EAP225 and that's just the same, so it's not the AP.
I've tried factory resetting everything including the router, but still no joy!
I've tried the AP direct on the router with a power brick or via POE on one of the switches without success.
Also tried different new cat6 patch cables. All AP's are hard wired, not Mesh connected.
Firmware is up to date on all TP-Link AP's and OC200.
Any Ideas please?
Also on one of the AP's that is connected to the OC200 controller, when i click on devices, then click on the AP,
and i look at channel utilization it's showing channel 1 (2.4G) 28% all in orange (Busy) what does this Busy mean?
& channel 48 (5G) 3% in orange (Busy). It's not showing me RX/TX Frames and interference like the other two connected AP's.
Why is this?
Any help much appreciated, I'm not an IT Engineer i'm afraid, but have set these up in the past with no problems. TIA
Hi thanks for your reply.
Here is rough drawing of my system:
It's the EAP in the lounge that i can't add to the controller, so i just have it as a stand alone.
But i did even try it in the office direct to the sky router with a PSU and it still wouldn't adopt it.
As i said i tried new cat6 moulded patch cables and another new EAP225 as well with no success.
Log just says (Failed)Master Cloud Administrator failed to adopt.
Here are some images from the controller, still want to know why the Landing AP just says Busy in orange?
Usually it says the RX and TX with the interference in orange. But this AP seems to be working ok.
