ER605 and ipv6 on Verizon Fios

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 and ipv6 on Verizon Fios

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

kes601

2022-09-02 13:19:20 - last edited 2022-09-06 20:18:24

Posts: 9

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-09-02

ER605 and ipv6 on Verizon Fios

2022-09-02 13:19:20 - last edited 2022-09-06 20:18:24

Model: ER605 (TL-R605)

Hardware Version: V2

Firmware Version: 2.0

Any suggestions on getting ipv6 working with the ER605 and Verizon Fios? It was working fine w/a previous Actiontec. I believe for WAN it is supposed to be stateless and then 56 for the prefix. If I put those in then it will change the link to up and I'll get a gateway address, but I never get an ipv6 address and ipv6 tests fail.

1 Accepted Solution

Virgo

LV5

2022-09-05 11:41:00 - last edited 2022-09-06 20:18:24

Posts: 2588

Helpful: 362

Solutions: 191

Stories: 0

Registered: 2021-05-10

Re:ER605 and ipv6 on Verizon Fios-Solution

2022-09-05 11:41:00 - last edited 2022-09-06 20:18:24

@kes601

Did you also set IPV6 on the LAN page? Lan should use the prefix obtained by wan from the ISP.
WAN IP is obtained normally, right?

Just striving to develop myself while helping others.

ER605 and ipv6 on Verizon Fios

ER605 and ipv6 on Verizon Fios

Information

Voters 0

Tags