Dear @Nandus ,

Nandus wrote

I have two WANs

WAN and WAN/LAN1

I have one Network (Lindetalgemeinde_Uebersetung), which should only use WAN/LAN1 as WAN.

If I connect to the SSID Translation whith the VLAN ID 120 it uses only WAN instead of WAN/LAN1. So where is my mistake?

To help you better, what is your specific router, EAP model number?
May I know the version of your controller?

Actually how did you test that it did not go to a specific WAN port?
We suggest that you may use tracert to test it and try comparing the IP of the WAN port.

Best Regards!

 Dear @Nandus,

Nandus wrote

Controller: OC200 1.0 Version 5.0.29 Firmware: 1.14.2 Build 20211215 Rel.61111

 

	Router	CONNECTED	TL-R05 v1.0	1.1.1
	Mainswitch	CONNECTED	TL-SG3428MP v1.0	1.1.2
	Switch 1	CONNECTED	TL-SG2210P v3.20	3.20.2
	Switch 2	CONNECTED	TL-SG2210P v3.20	3.20.2
	AP1	CONNECTED	EAP225(EU) v3.0	5.0.5
	AP2	CONNECTED	EAP620 HD(EU) v2.0	1.0.1
	AP3	CONNECTED	EAP225(EU) v3.0	5.0.5
	AP4	CONNECTED	EAP225(EU) v3.0	5.0.5
	AP5	CONNECTED	EAP225(EU) v3.0	5.0.5

I use a traceroute tool on my iphone.

The 1st hop was different (different gateway IP). The other hops are the same.

Thanks for these information, and checked that you have some devices's firmware is not the latest one.

You can try upgrading the controller's version to 5.0.30 to test.

Best Regards!