Dear @Crazy-C ,

Crazy-C wrote

I'm struggling to work out how to input the rtsp stream information into the NVR1008H interface. It suggests that the resource path should merely be the Stream number but where does the full URL get entered. Works fine on VLC. It is a Samsung snh-p6410.

You can try going to the page and clicking Add manually and selecting RTSP, and type in the IP address and account as shown below:

Best Regards!

Dear @Crazy-C ，

This device doesn't support adding directly through the url, can you send us the url you used to add on VLC?

Please note: When adding to the NVR, make sure that the parameters you fill in are the same as the information in the url.
Can you check if you can ping the IP address of the camera on the NVR?

Best Regards！

Dear @Crazy-C ,

If you can use onvif to add, it is suggestion to use it to add.

If you can not, please try to click Manage RTSP, and note in the Resource path only type in profile5/media.smb to have a try like below.

Best Regards!