ER605 VPN routing failure

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 VPN routing failure

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 VPN routing failure
ER605 VPN routing failure
2021-11-22 13:55:18 - last edited 2021-11-23 00:49:40
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.1.1 Build 20210723 Rel.64608

I purchased this unit as a vpn server for my remote network to replace an aging asus that was currently managing my vpn. This unit has proven to be quite difficult to set up successfully as the vpn, once configured. will connect but fails to route any traffic to the lan.

Multiple configurations end up with the same result, a failed vpn route. 

 

Although the asus is much easier to manage, I'm reluctant to pull the ER605 offline and replace it with my asus but, might not have a choice if I can't get it to a functional state,as I use the vpn to manage all my backup images, both remotely and on my local lan.

 

The asus and an even older sonicwall vpn router were much easier to configure and manage.

 

I find the ER605 interface confusing and difficult.

  0      
  0      
#1
Options
5 Reply
Re:ER605 VPN routing failure
2021-11-23 09:43:24

@KS10 

 

Just to confirm.
What kind of VPN are you setting up?(PPTP, L2TP, LAN-LAN IPsec or something like this ?)
Does it show the tunnel on this ER605 after you set it up?

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:ER605 VPN routing failure
2021-11-23 23:58:10

@Virgo 

 

It is a PPTP connection that I am able to connect to from the remote machine.

I'm pulling an internal IP that is configured in the VPN scope.

The tunnel does show up on the ER605 once configured.

  0  
  0  
#3
Options
Re:ER605 VPN routing failure
2021-11-24 07:48:32

@KS10 

 

Is there another NAT device on the front of your ER605?
Is the WAN IP of your ER605 a public IP?

 

Here is an article you can refer to:

https://www.tp-link.com/en/support/faq/3026/

https://www.tp-link.com/en/support/faq/3044/

Just striving to develop myself while helping others.
  0  
  0  
#4
Options
Re:ER605 VPN routing failure
2021-11-26 01:51:41

@Virgo 

Thank you for the response. 

There is no front end NAT device on the WAN side of the router.

The WAN does indeed have a public IP.

  0  
  0  
#5
Options
Re:ER605 VPN routing failure
2021-12-02 06:30:53

Dear @KS10,

 

KS10 wrote

I purchased this unit as a vpn server for my remote network to replace an aging asus that was currently managing my vpn. This unit has proven to be quite difficult to set up successfully as the vpn, once configured. will connect but fails to route any traffic to the lan.

Multiple configurations end up with the same result, a failed vpn route. 

 

I'd highly suggest you follow the FAQ below and see if it helps.

What to do if you cannot access the remote network through Client-to-LAN/Site VPN tunnel

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#6
Options